English 
搜索
Hebei Lansheng Biotech Co., Ltd. ShangHai Yuelian Biotech Co., Ltd.

Best practices to improve resource efficiency using adjuvants for biopesticidesqrcode

May. 24, 2021

Favorites Print
Forward
May. 24, 2021

P1170219(05-24-16-01-19)2.jpg

Daniel Zweifel
Application Technology Leader at Dow Europe GmbH


SUMMARY


A selection of nonionic surfactants based on linear and secondary alcohol alkoxylates as well as alkyl polyglycosides, which to varying degrees are made from renewable chemistries, were evaluated as co-formulants for biopesticides.  Properties such as wetting performance, contact angle, phytotoxicity, and fungal and bacterial growth inhibition were considered for the selection of adjuvants in the study. Key functional performance parameters such as spreading index, compatibility with corn leaves, and growth inhibition were evaluated using six different strains: Paraburkholderia phytofirmans PsJN, Bacillus endophyticus, Pseudomonas fluorescens, and Bacillus simplex, Trichoderma virens (fungus), Rhizobium cellulosilyticum and Trichoderma viride (fungus).

Significant differences in the zones of inhibition among the different surfactants were observed. Many products did not show inhibition, whereas some had an inhibition zone of up to 5 mm compared to a traditional biocide. The effects can be attributed to the sensitivity of the microbes tested as well as to the surfactants themselves. Different surfactant structures have an effect on the surfactant properties and performance.


INTRODUCTION


The market for general biological control products is complex and there exist many subsectors. In 2018 more biopesticide products were introduced to the market than conventional crop protection products. (McDougall, Phillips 2018, Evolution of the Crop Protection Industry since 1960, 5-7) Biopesticides offer formulators multiple benefits including support of plant growth & root health, contributions to improved soil microbiome stability, and improved availability and uptake of specific nutrients by the plants.

The use of microbial products has certain advantages over conventional chemicals; they are considered safer than many of the chemicals now in use, they do not accumulate in the food chain, the target organisms seldom develop resistance as is the case when chemical agents are used, and properly-developed biocontrol agents are not considered harmful to ecological processes nor the environment (Travis R. Glare, et al (2016): Development of Biopesticides and Future Opportunities. Microbial-Based Biopesticides pp 211-221.)

Given the potential benefits of biopesticides, either used alone or in combination with conventional crop protection options, it is important to understand the role of co-formulants that enhance the benefits of biopesticides and enable resource efficiency.  A formulated biopesticide needs to have good storage stability, should show high efficiency in the application as well as good uptake of product into the plant.  Co-formulants must be effective in maintaining the viability of the active ingredient (bacteria or fungus) and enhancing the availability to the plant, in order to gain full advantage of the beneficial effects of the formulation. In this article, we demonstrate the effect of the surfactants on biopesticidal formulations and show a selection of molds and bacteria species for biopesticidal uses.

We will cover the methodology how to measure compatibility and how to come to test results.

The surfactants should not sacrifice the performance of the fungi and bacteria. Tests conducted in lab scale at Dow should help to advance the selection products to be further tested at customers and scaled up to field trials.


MATERIALS AND METHODS

Surfactants


A selection of nonionic surfactants based on linear and secondary alcohol alkoxylates as well as alkyl polyglycosides, which are in varying degrees made from renewable chemistries, were chosen to evaluate their performance as co-formulants for biopesticides. 1% (w/w) water solutions were prepared for all the surfactants tested. Products based on a variety of different surfactants were selected based on various criteria (Table 1).


图片1.png

Table 1: Non-ionic surfactants
Notes: Typical properties, not to be construed as product specification.


Strains


Six market-relevant biocontrol or bio fertilizer strains were obtained from various strain collections (Bacillus endophyticus, Bacillus simplex, Rhizobium cellulosilyticum, and Trichoderma viride: customer samples; Paraburkholderia phytofirmans: AIT, Trichoderma virens: DSMZ 1963 and Pseudomonas fluorescens: DSMZ 50091) and have been examined for compatibility with the adjuvant systems (Table 2).

图片2.png

Table 2: List of strains used to assess the compatibility with adjuvants


Bacteria strains were plated out on TSA plates and harvested after 1 day at 30°C into PBS buffer at pH 7. The fungi were plated on MEA plates and harvested after 7 days at 28°C into a phosphate citrate buffer at pH 5. All the surfactants were diluted in Elix Water to a concentration of 1wt%.

The round coupons with a diameter of 3cm were cut out from Whatman °41 filter paper.

Prior to the application the fungi were homogenized. Bacteria strains were streaked with cotton sticks onto TSA plates using a z-pattern; the plate turned about 120° and the z-pattern applied again. The fungi and bacteria strains were streaked with cotton sticks onto MEA plates using a z-pattern, the plate turned about 120° and a z-pattern applied again. The coupons were immersed in surfactant solution for a few seconds, removed and excess liquid drained by waiting for a few seconds. Elix water and DBNPA 20% (Bioban DB20) were used as controls.

The coupons were placed on to the agar plates and air bubbles below the coupons were removed. (Figure 1)


图片3.png

Figure 1: Test set-up with Petri dishes


The plates were incubated for 2 days at 30°C for bacteria strains and at 28°C for the fungi strains. The inhibition zone was measured (in mm) and the growth over the coupons was rated from 1 (<10% growth over) to 4 (>60% grow over) (Figure 2 and Table 3)


RESULTS AND DISCUSSION


Specific differences in the zones of inhibition between the surfactants were observed. Many products did not show inhibition (Figure 2) depicted as green boxes, whereas some had an inhibition zone around the coupons up to 5mm. The traditional biocide had an inhibition zone of > 20mm. These effects can be attributed to the sensitivities of the microbes tested as well as to the surfactants themselves. Different surfactant structures have an effect on the surfactant properties and performance.


图片4.png

Figure 2: Pictures of petri dishes with coupons immersed in surfactants


Based on the results, it is concluded that the incorporation of specific surfactants can help exhibit improved wetting and spreading properties to the formulation. Negative side effects on scorching with the tested adjuvants and substantial microbe inhibition were not observed.

The microbes Pseudomonas fluorescens, Trichoderma virens (fungus), Rhizobium cellulosilyticum and Trichoderma viride do not exhibit any inhibition properties with all the surfactants tested.

Paraburkholderia phytofirmans, PsJN, Bacillus endophyticus and Bacillus simplex show very low inhibition in the range from 1–5mm with the surfactants tested. Paraburkholderia phytofirmans, PsJN shows slight inhibition with ECOSURF™ EH-6 only. Bacillus endophyticus shows a 5mm inhibition zone with TERGITOL™ 15-S-7 and a minor inhibition (< 2 mm) with ECOSURF™ EH-6 and ECOSURF™ SA-9.

Bacillus simplex shows an inhibition zone of 5 mm with TERGITOL™ 15-S-7 and 4 mm with ECOSURF™ SA-9. All other formulations exhibit no inhibition zones at all. Surprisingly many of these developed significant growth over zones (>60%) such as Tirchoderma virens and Trichoderma viride with all adjuvants tested.

The co-formulants tested exhibit good profile properties for bio pesticide uses. They do not exhibit negative effects upon the biological activity of the microbes.  Therefore, they may be considered for use within biological systems (Table 3).



图片5.png

Table 3: Test results of the compatibility of adjuvants with strains


About the Author:

Daniel Zweifel is engaged in Crop Defense Solutions since 2015 as Application Technology Leader at Dow Europe GmbH;

Over 20 years industry experience in application technology in the agricultural, lubricants and construction industry;

Experienced Six Sigma Black Belt Project Leader.


图片6.png

Source: Dow

0/1200

More from AgroNewsChange

Hot Topic More

I wanna post a press Comment

Subscribe 

Subscribe Email: *
Name:
Mobile Number:  

Comment  

0/1200

 

NEWSLETTER

Subscribe BioEx Biweekly to send news related to your mailbox